Ios 4.x / ios5.x jailbreak ios9.2 – ios9.3.3 jailbreak You can easily jailbreak your iPhone using 3utools apps.
#3utools stuck at 19 install#
Ios users who like to customize their idevice using beyond the Apple app store install cydia apps need to jailbreak their i-device.ģutools offers jailbreak options you for free.
#3utools stuck at 19 drivers#
Repair drivers with the iTunes Utility in Toolbox and flash again later\n -ġ1:37:54.Watch Full VideoAll Solution freeLike/Comment/Subscribe/Share#JavedMobileGsmSubscribe My Channel. Connect another genuine cable to the rear USB port of a fully powered case\n 2. If it is not a hardware error, you may consider:\n 1. I need to test other lines, do you know if every line is powered on when Phone is in DFU mode ?ġ1:37:47.801: Recovery mode device disconnectedġ1:37:47.801: Device removed when in state Restoring, moving device to transition stateġ1:37:47.801: Changing state from 'Restoring' to 'Transitioning'ġ1:37:47.801: Waiting for the iDevice to reconnect after switch mode completed.
#3utools stuck at 19 plus#
But on this Intel iphone 7 plus there is no PP_LDOxVx… so I don’t really know what I need to test. When the phone is ON, I have 0V in voltmeter test on VDD_REFCP, VDD_DDR_1V8, VPMIC_RF. Phone is in Recovery Mode from 11% (Enter Recovery Mode) to 18% (Kernel Cache) : does it mean that it can access Nand ?Īround BB_PMU I didn’t find any voltage. If it can go to 19%, does it mean that RAM is ok ? Phone is charging and detected by iTunes, so does it mean that Tristar is ok ? Here are some questions about possible faulty components : With 3uTools it stops between 18% (sending Kernel Cache) and 19% (restoring) : what I understand is that instead of going to Normal mode, it returns to DFU Mode. I tried to restore with iTunes : Apple logo appeared, but error 4014. It is impossible to get into Normal mode with Power and VOL- : it comes back to DFU. The phone is detected by iTunes, there is no image, and it is in DFU mode. On DCPS power, it draws 10mA, and when I press power it draws 125mA for 5 sec, and then it stays at 90mA. I think it is battery charging because now battery is charged. On USB charger, it directly draws 440mA, without any change.
The only low value is PP_GPU_VAR (0V in voltmeter test and 0,005V in diode mode test) but I think it’s normal to have low resistance on this line. Now every power value is ok in diode mode test and in voltmeter test : I also removed NFC_RF chip which was getting hot. There were some shorted capacitors that I removed. I have a water damaged Intel iphone 7 Plus.
0 kommentar(er)
